FORTIN UNIVERSAL ALL-IN-ONE DATA BYPASS AND INTERFACE MODULE.

Universal All-In-One Data Bypass and Interface Module.

The EVO-ALLis an ALL-IN-ONE data immobilizer bypass and doorlock interface combomodule. It raises the standard of hassle-free installation convenienceto a whole new level. It uses a multiple bus architecture with 10separate communication ports that provide more complete functionality onevery supported vehicle.

Click here to see vehicle fit

Product Features

• 3x on-board LEDs for simplified programming and diagnostics.
• 1x preloaded firmware for maximum compatibility. ^[1]
• 4-wire Fortin 2-way datalink port for data-to-data (RS-232) communication with datalink equipped remote-starters and security-systems.^[2]
• 20-wire general purpose plug for wire-to-wire connections with non-datalink equipped remote-starters and security-systems.
• Self-Learning algorithm automatically detects the vehicle during programming and adjusts accordingly.

Communication Ports

• 3x CAN-Bus controllers.
• 3x General purpose controllers (J1850, Class 2, encrypted key etc.).
• 2x On-board Relays (SPDT).
• 1x Analog Controller 0-12VDC @ 20mV steps (Passlock, MUX).
• 1x TB control port for TB-series modules. ^[3]

Parts Included

• 1x EVO-ALL control module (firmware preloaded). ^[4]
• 1x 44-page Installation and programming guide. ^[4]
• 1x 20-pin General purpose harness ^[5].
• 1x 4-pin Fortin 2-way data-link harness. ^[2]
• 1x 5-pin CAN-Bus harness.
• 1x 6-pin Relay harness. ^[5]

______________________________________

To Integrate Fortin EVO-ALL  with Compustar RF Kits

First, make sure the EVO-ALL option H3 is selected.

Also make sure that you reverse the RX and TX wires in the Datalink.

Here is the programming for the remote to our EVO-ALL:

1.    Put the EVO-ALL in programming mode, release programming button on BLUE/RED

2.    Press and hold the programming button on EVO-ALL for 5 seconds. The 2 LED’s will shut down and turn back ON after 5 seconds.

3.    Turn the Ignition ON.

4.    Press the “Lock” or button on remote you wish to program.You can also press the “Start” button, but you will have to hold it for 3 seconds.

5.    The BLUE and RED LED’s will flash once to confirm remote is coded.

6.    To program additional remotes press the Lock or Start button of each remote.

  7.    Turn Ignition OFF once all remotes have been programmed.

_______________________________________ 

[1] A firmware update may be required for the module to support vehicles produced after the date of manufacture.

[2] Using the 2-way datalink port with an equipped remote-starter and security-system greatly simplifies installation. Click here to learn more.

[3] TB-series modules sold separately.

[4] Update firmware and installation guides are posted on a regularbasis. We recommend that you update this module to the latest firmwareand download the latest installation guide(s) prior to the installationof this product.

[5] Secure Clip Harness.

.